10
Not$used$
Input,$Fused$5$amp.,$
Engine$Igni5on$(+)$
Switched$On.$
Wire$Interface$Connector$PinCOut$
J1939$Connector$PinCOut$
Deutsch$Connector$
DT04C3P$
GENERAL WIRING INSTALLATION PROCEDURE:
CAUTION
KSM Power Stud Nuts should be torqued to 180 Inch Pounds.
CONNECTORS LOCATED ON THE END-FACEPLATE OF THE KSM ENCLOSURE.
END-FACEPLATE OF THE
KSM ENCLOSURE.
The J1939 connector is used for KBI Factory
programing only. Contact KBI for details.
Discrete Signal
See schematic, page 13
