Kohler Sterling 7613 Series, Руководство по установке

Страница: 16 / 56

11. Complete the Finished Wall
NOTE: Locate and size the holes for the valves, shower control, spout, and/or shower in the walls
according to the manufacturer’s requirements.
IMPORTANT!
When applying the water-resistant wall material over the whirlpool flange, leave a 1/4
″
(6
mm) gap between the whirlpool rim edge and the wall material. This gap helps to reduce the possibility
of water seeping into the wall material.
Brush all dust and debris from the whirlpool flange.
Cover the framing with water-resistant wall material.
Seal the 1/4
″
(6 mm) gap between the whirlpool rim edge and the water-resistant wall material with
clear 100% silicone sealant.
12. Finish the Installation
CAUTION: Risk of property damage. Make sure that a watertight seal exists around the drain and
overflow.
Install the faucet trim, whirlpool spout, shower door, and any accessories according to each
manufacturer’s instructions.
Remove the protective covering from the whirlpool.
Open the water supply lines, then run the water to flush out any debris.
Close the valves.
Check all connections for leaks.
If applicable, install all other accessories according to the manufacturer’s instructions.
1/4" (6 mm)
Finished Wall
Whirlpool with Water-Resistant
Wall Material and Finished Wall
Whirlpool Flange
Tile or Other
Wall Finish
Whirlpool with Tile,
Marble, Etc.
Water-Resistant
Wall Material
Water-Resistant
Wall Material
1/4" (6 mm)
Whirlpool Flange Clear 100%
Silicone Sealant
Clear 100%
Silicone Sealant
1072813-2-A 16 Sterling