2. After wire layout finished, check and repair if needed.
Then connect AC connector of AC/DC transformer to
electrical source from the control box, and DC connector of
AC/DC transformer to faucet. Turn on AC electrical power,
faucet will be in the period of automatic adjusting sensing
distance (about 2 minutes). The faucet will not work during
this period.
直流连接线采用导体标称截面积
mm
的电线。
请严格按照上图进行连接。
0.3
1.
电源盒
(
背面有不干胶
)
应安装在干燥，不会被水
淋湿、浸泡的位置。根据需要客户自备穿线管及
连接线。穿线管安装在墙内。建议交流电源线采用
带绝缘和护套层的电线，导体标称截面积
0.5mm
;
2.
排线完毕后，应检查并确保所有排、接线无误，
再分别连接电源盒
AC
接线端与排线管内交流接线
端，以及电源盒
DC
接线端
(
黑橙线接头
)
与龙头的
电源线接插件（从阀盒内引出的电线），最后打
开
AC
电源，龙头进入
2
分钟自动调距阶段，此
过程龙头不会出水。
1321280-T01-A
8
2
2
感应龙头
Faucet
超能动电池系统
G1/2
Please prepare
external thread
angle valve G1/2
HOW TO INSTALL THE Hybrid
Energy System
(If using hybrid energy
system
K-13683T
as power supply, please
refer to its installation instruction)
台盆顶面
如何安装超能动电池系统
(若用户
另购
超能动电池
K-13683T,
具体安
装详见其说明书)
1. AC power unit (sticker on the back) should be installed at
a dry place, and avoid showering, soaking from water.
Customer prepare wire tube and wire according to
requirement. Wire tube should be put into the wall.
Suggested wire:AC connection wire should with insulated
protecting layer or sleeve and the section should ≥ 0.5mm².
The section of DC connection
wire should ≥ 0.3mm².The
connection pattern must a
ccording to illustrations above.
