Kohler K-97260X, Руководство по установке и эксплуатации

Страница: 5 / 24

CAUTION : Risk of product damage. Do not lift the bath by the piping or pump, or use the piping or pump
for structural support of the bath.
Bath Installation
Prepare the Bath
□ When removing bath. Do not lift bath by pipe work. Inspect for any possible damage that may have occurred
in transit.
□ Insert the drain tailpiece into the trap. Make sure the bath is level. Use silicone to seal between drain and trap.
□ Seal the joint between the bath rim and the finished tiled wall using silicone sealant.
□ Ensure adjustable feet are fitted through holes drilled in support frame.
□ Locate bath in proposed position. The protect film originally covering your spa has been recovered to fit its
equipment, therefore, carefully protect its surface during installation.
□ Make sure the bath is level (and resting on all support blocks).
□ Install the drain to the bath according to the drain manufacturer’s instructions. Do not connect the trap
at this time.
□ To adjust the height, loosen the nut A, adjust the height by tightening the nut B, and then tighten the nut A.
□ Position the bath on the support, adjust the level.
Bath rim must be fully supported.
560-600 mm
Bath
Pipe
Adjust and lock to recommended height.
Adjust the nut A to lock/unlock
the adjustable feet.
Adjust the height of the bath
by tightening the nut B.
A
B
Bath must be installed level on all top edges.
Plumbing Installation
NOTE : An access panel will simplify future maintenance.
□ Connect the drain to the trap according to the drain manufacturer’s instructions.
□ Open the hot and cold water supplies, and check the supply connections for leakage.
□ Run water into the bath, and check the drain connections for leakage.
CAUTION : Risk of product damage. Ensure a watertight seal on the bath drain.
Kohler Co. 5 1241693-X2-B