Kohler K-97260X, Руководство по установке и эксплуатации

Страница: 4 / 24

CAUTION : Risk of product damage. Do not support the bath by the rim.
Prepare the Site
Concrete Construction
NOTICE : Adequate floor support must be provided. Consult the roughing-in sheet packed with your bath for
specific floor loading requirements.
NOTICE : Unless otherwise specified, floor support under the bath must provide for a minimum 390 kg/square
meter loading.
NOTICE: Provide adequate ventilation and a minimum of 15 cubic feet (0.4 cubic meters) in the installed location
for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor closer than 2.5 mm
from the wall or other objects.
□ Make sure the flooring offers adequate support for your bath, and verify that the subfloor is flat and level.
□ This bath may be installed next to the wall or in an island installation. An island installation requires a four
side surround. In both instances, make sure the deck is supported by brick or concrete.
□ Install an access panel to allow the pump to be serviced.
□ Construct brick or concrete supports.
□ Provide 2 mm gap between the bath rim and the concrete or brick framing. Frame the floor, or construct
a frame for a raised installation, in accordance with the roughing-in information packed with the bath.
□ Position the plumbing according to the roughing-in information packed. Cap the supplies, and check for leaks.
Typical
Access
Panel
Whirlpool may be installed next to
the wall or as an island installation.
Install an access panel to allow
the pump to be serviced.
Bath
2 mm
Approved
Tile Backing
Approved
Tile Backing
Tile
Brick
Tile
Brick
1/2" Water Supply
Power Supply
300-400
Ø
2" Outlet
1500
500-700
1241693-X2-B 4 Kohler Co.