Kohler K-97260X, Руководство по установке и эксплуатации

Страница: 10 / 24

1st push
Motor Pump on / Heater on.
2nd push
Motor Pump on / Heater off.
3rd push
Motor Pump off / Heater off.
D. Air Bubble Volume Control
Turn the knob clockwise to increase air bubble volume and turn counterclockwise to decrease air bubble volume in
whirlpool system.
Switch Function and Operation (Cont.)
C. Motor Pump/Heater On/Off Control
Allows bather to switch off the heater when not required.
E. Auto Sanitising Cycle
Auto clean up cycle will commence 20 minutes after the bath has been emptied of water. The blower and heater
will then restart and operate for 2 minutes sanitising the system with hot air before automatically shutting down.
F. Auto Timer
The auto safety timer will shut the air/spa system down automatically after 30 minutes of continual operation,
and can be restarted again by pressing the electronic ON/OFF switch.
IMPORTANT : Air spa system will only operate for 5 seconds if insufficient water level is detected, automatically
shutting down.
G. Leakage Detection
Leakage Detection indicator
When the fixture is powered on and the bath has run out of water,
press Blower Speed Decrease button, Blower Speed Increase button and
Motor/Pump-Heater button simultaneously for more than 3 seconds to
create a simulation of electricity leakage, then the indicator will flash in
red and green alternatively. This indicates the leakage detection function
is well in use, otherwise, there’s possibility that this function fails to
operate normally and may result in electric shock accident.
Release three buttons and the bath will not function anymore if any key
is pressed. Make the bath powered-on again and the bath will restore its
function.
Power
Water
Fault
Indicator flashes in red
and green alternatively.
Indicator lights in red
Indicator lights in blue
Indicator turns off
Turn counterclockwise to decrease
air bubble volume in whrilpool
Turn clockwise to increase
air bubble volume in whirlpool
1241693-X2-B 10 Kohler Co.