9
INSTALL THE WHIRLPOOL TRIM KIT
INSTALL THE WHIRLPOOL TRIM KIT
·
·
·
·
Install the whirlpool trim kit according to the
instructions packed with the trim kit. Pay particular
attention to the jet installation steps below - they are
very important and are included here to help you
obtain smooth, trouble-free jet operation. When
installed correctly, the jet should turn smoothly both
clockwise and counterclockwise.
The jet O-ring must be carefully positioned,
lubricated, and be in good condition to permit easy
rotation and proper operation of the jet.
Lubricate the O-ring with silicone lubricant to
prevent noisy operation of the jet.
Install the O-ring onto
of the jet.
Carefully insert the jet into the housing, and lightly
push and rotate the jet until it snaps into position.
NOTE:
the first shoulder
Do not force the jet into place.
·
·
·
·
O
O
O
Housing
Slide the o-ring onto
the first shoulder of the jet
O
Inspect and lubricate
the o-ring
O
Insert the jet into the
housing, and lightly push
and rotate until it snaps
in position
TEST RUN THE WHIRLPOOL
TEST RUN THE WHIRLPOOL
·
·
·
·
·
·
·
Check all electrical connections, then make sure all
union connections to the pumps and heaters are
securely hand tightened.
Verify both sets of pump banding straps have been
cut and the pump controls are resting directly on the
subfloor. Ensure the rubber isolation feet are in
place.
Turn electrical power to both pumps on.
Fill the whirlpool with water until the water level is
above the highest backjet.
Operate the whirlpool for 5 minutes (refer to the
"Operating Sequence" section). Three small lights
near the whirlpool floor will illuminate as long as the
keypad remains lit. The keypad controls the
chromatherapy feature.
Check for leaks coming from the piping connections
on the back side of the whirlpool unit.
Turn on the each of the whirlpool features and verify
proper function. Check for any water leakage on the
whirlpool's back side.
·
·
·
·
·
·
·
5
(
)
1141609-T01-A
