4
·
·
·
·
·
·
·
·
·
·
1/16
(2
)
CAUTION: Risk of product damage.
NOTICE:
Do not
support the whirlpool by the rim.
Adequate floor support must be provided.
Consult the roughing-in sheet packed with your
whirlpool for specific floor loading requirements.
·
·
·
·
·
·
·
·
·
·
If you have not already done so, carefully remove
the protective tape from the whirlpool rim.
Apply mortar and tile to the wall, deck and surround
material as needed.
Apply a bead of sealant where the tile meets the
whirlpool surface.
Install the faucet trim according to the instructions
packed with the trim.
Make sure the flooring offers adequate support for
your whirlpool, and verify that the subfloor is flat and
level.
The whirlpool may be installed as next to the wall or
in an island installation. An island installation
requires a four side surround. In both instances,
make sure the deck is supported by brick or
concrete.
Install an access panel to allow the pump to be
serviced.
Construct brick or concrete supports.
Provide a 2mm gap between the whirlpool rim and
the concrete or brick framing. Frame the floor or
construct a frame for a raised installation in
accordance with the roughing-in information packed
with the whirlpool.
Position the plumbing according to the roughing-in
information packed. Cap the supplies, and check for
leaks.
PREPARE THE SITE - CONCRETE CONSTRUCTION
PREPARE THE SITE - CONCRETE CONSTRUCTION
Bath
Brick
Approved Tile
Backing
Install an access panel to
allow the pump to be serviced.
Whirlpool may be installed next
to the wall or as an island installation.
Approved Tile Backing
2mm
Tile
Typical
Access
Panel
Brick
Tile
1141609-T01-A
