·
·
Turn on the chromatherapy cycle and allow it to
sequence through all eight colors; white, violet,
indigo blue, aqua blue, green, yellow, orange and
red. It takes approximately 1 minute to cycle through
all eight colors.
Verify functions using the remote controls. Refer to
the Remote Control Operation section of this guide
and supplemental instruction sheet, Programming
Your Remote Controls , packed with your literature.
For additional information on whirlpool
operation, see the Confirm Proper Operation section
of this guide.
NOTE:
"
"
"
"
"
"
·
·
8
8
1
10
·
·
·
·
If you have not already done so, carefully remove
the protective tape from the whirlpool rim.
Cover the framing with water-resistant wall material.
Seal the joints between the whirlpool rim edge and
the water-resistant wall material with silicone sealant.
Tape and mud the water-resistant wall material.
Install the finished wall to the water-resistant wall
material so it is 2mm above the bath surface. Seal
the joints between the whirlpool rim and the finished
wall material with silicone sealant.
Install the faucet trim according to the instructions
packed with the trim.
·
·
·
·
/
/
/
/
/
/
2mm
COMPLETE THE FINISHED WALL/DECK
COMPLETE THE FINISHED WALL/DECK
Apply silicone sealant to the water-resistant
wall material and the finished wall.
Apply silicone sealant to the water-resistant
wall material and the finished wall.
Install the finished
wall material.
First install water-resistant
wall material.
Drop-In Installation
Install the finished wall
material.
First install water-resistant
wall material.
Flush Installation
Whirlpool
Whirlpool
1141609-T01-A