7.4
Section 7
Retractable Starter
Inspection and Service
1. Carefully inspect the rope, pawls, housing,
center screw, and other components for wear or
damage.
2. Replace all worn or damaged components.
Use only genuine Kohler replacement parts as
specifi ed in the Parts Manual. All components
shown in Figure 7-1 are available as service
parts. Do not use nonstandard parts.
3. Do not attempt to rewind a spring that has come
out of the keeper. Order and install a new spring
and keeper assembly.
4. Clean all old grease and dirt from the starter
components. Generously lubricate the spring
and center shaft with any commercially available
bearing grease.
Reassembly
1. Make sure the spring is well lubricated with
grease. Place the spring and keeper assembly
inside the pulley (with spring toward pulley). See
Figure 7-8.
Figure 7-8. Position of Spring and Keeper in Pulley.
2. Install the pulley and spring into the starter
housing. See Figure 7-9.
Make sure the pulley is fully seated against the
starter housing. Do not wind the pulley and recoil
spring at this time.
Figure 7-9. Installing Pulley and Spring into
Housing.
3. Install the pawl springs and pawls into the starter
pulley. See Figure 7-10.
Figure 7-10. Installing Pawls and Pawl Springs.
4. Place the brake washer in the recess in starter
pulley, over the center shaft.
5. Lubricate the brake spring sparingly with grease.
Place the spring on the plain washer. (Make sure
the threads in center shaft remain clean, dry, and
free of grease and oil.)
6. Apply a small amount of
Loctite
®
No. 271
to the
threads of the center screw. Install the center
screw, with washer and retainer, to the center
shaft. Torque the screw to
7.4-8.5 N·m
(65-75
in.
lb.)
.
7. Tension the spring and install the rope and
handle, as instructed in steps 6 through 12 under
‘‘Rope Replacement’’ on page 7.2.
8. Install the starter to the engine blower housing.
Pulley & Spring
Housing
Rope Hole
in Pulley
Outer Spring Hook
Spring &
Keeper
Pawl
Pawl Spring
Содержание CV11-16
