Kohler CV11-16, Руководство по обслуживанию

Страница: 115 / 150

10.3
Section 10
Inspection and Reconditioning
10
Figure 10-2. Removing Plug.
Crankcase
Inspection and Service
Check all gasket surfaces to make sure they are free
of gasket fragments. Gasket surfaces must also be
free of deep scratches or nicks.
Check the cylinder bore wall for scoring. In severe
cases, unburned fuel can cause scuffi ng and
scoring of the cylinder wall. It washes the necessary
lubricating oils off the piston and cylinder wall. As raw
fuel seeps down the cylinder wall, the piston rings
make metal to metal contact with the wall. Scoring
of the cylinder wall can also be caused by localized
hot spots resulting from blocked cooling fi ns or from
inadequate or contaminated lubrication.
If the cylinder bore is scored, worn, tapered, or
out-of-round, resizing is necessary. Use an inside
micrometer to determine amount of wear (refer to
the ‘‘Specifi cations, Tolerances, and Special Torque
Values’’, in Section 1), then select the nearest suitable
oversize of
0.08 mm (0.003 in.), 0.25 mm (0.010
in.), or 0.50 mm (0.020 in.) . Resizing to one of these
oversizes will allow usage of the available oversize
piston and ring assemblies. Replacement pistons
are manufactured to precise tolerances. It is not
necessary to "fi t" the piston to the cylinder. Start with
the new cylinder bore diameter (from Section 1), add
the desired oversize dimension, and machine the
cylinder to that exact size. The corresponding oversize
piston will then fi t the cylinder with the correct running
clearance.
Boring
When over-sizing to 0.25 mm (0.010 in.) or 0.50 mm
(0.020 in.), the initial resizing should be done with a
boring bar, until the cylinder is within 0.08-0.12 mm
(0.003-0.005 in.) of the desired size. Then use the
following procedures for honing to the fi nal dimension.
For 0.08 mm (0.003 in.) oversize, skip the boring bar
and go right to honing.
Honing
While most commercially available cylinder hones
can be used with either portable drills or drill presses,
the use of a low speed drill press is preferred as it
facilitates more accurate alignment of the bore in
relation to the crankshaft crossbore. Honing is best
accomplished at a drill speed of about
250 RPM and
60 strokes per minute. After installing coarse stones
in hone, proceed as follows:
1. Lower hone into bore and, after centering, adjust
so that the stones are in contact with the cylinder
wall. Use of a commercial cutting-cooling agent is
recommended.
2. With the lower edge of each stone positioned
even with the lowest edge of the bore, start drill
and honing process. Move the hone up and down
while resizing to prevent the formation of cutting
ridges. Check the size frequently. Make sure the
bore is cool when measuring.
3. When the bore is within 0.064 mm (0.0025 in.)
of desired size, remove the coarse stones and
replace with burnishing stones. Continue with the
burnishing stones until within
0.013 mm
(0.0005 in.) of desired size and then use fi nish
stones (220-280 grit) and polish to fi nal size. A
crosshatch should be observed if honing is done
correctly. The crosshatch should intersect at
approximately 23-33° off the horizontal. Too fl at
an angle could cause the rings to skip and wear
excessively, too steep an angle will result in high
oil consumption (refer to Figure 10-3).
Flat Washer
Self-Tapping Screw
Plug
Crankshaft