Kohler 1.4BEOR-12V, Операция

Страница: 29 / 44

TP-6687 9/10 29 Section 5 General Maintenance
4. Loosen and remove the wing nut in order to remove
the air filter. See Figure 5-16.
5. If the air filter is dirty or clogged, replace with a new
air filter.
1. Wing nut
2. Air filter
tp6576
1
2
Figure 5-16 Removing Air Filter
6. Before re-installing the air filter, make sure the
rubber gasket is intact or replace, if necessary. See
Figure 5-17.
1
1. Rubber gasket
tp6576
Figure 5-17 Rubber Gasket
7. Remove four screws to disassemble the prefilter
and check for clogging. If necessary, remove it
from its position on the lower part of the air filter
cover. Clean if clogged by blowing air through the
prefilter. See Figure 5-18.
1
1. Prefilter
2. Air filter cover
tp6576
1
2
Figure 5-18 Prefilter
8. After cleaning, replace the prefilter on the air filter
cover.
9. Reassemble the air filter, making sure that the
rubber gasket is in the proper position, then tighten
the wingnut.
10. Make sure the air filter is mounted correctly to
prevent dust or impurities entering the intake ducts.
11. Re-attach the air filter cover again by turning the
knob clockwise.
5.5 Control Operation Following
Maintenance
If leaks or dripping are found, operate as follows:
1. If the leaks are due to incorrect assembly of
components, correctly reassemble the pipes and/
or components that have been modified.
2. If the leaks are due to breakage or system
irregularities, contact an authorized Kohler
distributor/dealer.
After completing the maintenance operations, replace
the access panels on the power unit enclosure with the
supplied plastic key. See Figure 5-5.