Kohler 1.4BEOR-12V, Операция

Страница: 26 / 44

TP-6687 9/10 26 Section 5 General Maintenance
1. Master On/Off switch
2. Oil fill cap
1
2
Top View of Unit
Figure 5-6 Master On/Off Switch and Oil Fill
6. Remove the dipstick and check the oil level. The
right oil level is close to, but not above, the MAX
mark. When the level is below or just above the
MIN mark, it is time to add oil. See Figure 5-4.
7. To add oil, unscrew and remove the oil fill cap and
add the amount of oil needed using a funnel. See
Figure 5-6.
8. Now check the oil level again using the dipstick as
indicated in step 6.
9. After you have correctly checked the level and
refilled with oil, replace the dipstick, insert and
screw on the oil fill cap, and correctly replace the
enclosure access panel, tightening the lock with
the aid of the supplied plastic key.
5.3.4 Oil and Filter Replacement
Replace the oil and oil filter every 500 hours. Contact an
authorized Kohler distributor/dealer. If the unit is used
infrequently, change oil every six months.
Use the following procedure to replace the lubricating oil
and oil filter. Refer to Section 5.3.3 for recommended
oil.
1. Make sure the vehicle is on a level surface and is at
a complete rest.
2. Wear special protective gloves and clothing for
maintenance operations.
3. Contact with used engine oil may cause severe
skin irritation. Repeated and prolonged skin
exposure may have other health risks. Used
engine oil is a suspected carcinogen. Avoid
contact with skin. Thoroughly wash your hands
and nails with soap and water shortly after handling
used engine oil. Wash or dispose of clothing or
rags containing used engine oil. Dispose of used
engine oil in a responsible manner. Contact your
local recycling center for disposal information and
locations.
4. Unlock the top access panel on the power unit
enclosure with the supplied plastic key. See
Figure 5-5.
5. Turn the master control switch (see Figure 5-6) to
the OFF position.
6. Unscrew and remove the oil fill cap to make it
easier to empty the oil from the engine. See
Figure 5-6.
7. Unscrew the oil drain plug on the bottom of the
power unit in order to drain all the oil from the
engine. When it is completely drained, insert the oil
drain plug and tighten it using a wrench.
See
Figure 5-7 and Figure 5-8.
1
tp6576
1. Oil drain plug
Front View of Unit
Figure 5-7 Oil Drain Plug Location
1
tp6576
1. Wrench
Figure 5-8 Tightening Oil Drain Plug