16
1. Switch on
the pullcord or wall
mounted switch. The
power
neon will provide a visual
indication that the switch is on.
2.
Press the
start
button.
3.
Rotate the
top
control knob to
the
HIGH
position
(Full Power).
4.
Wait
15-20
seconds for warm
water to reach the showerhead.
5.
If necessary turn the
bottom
control knob slowly to adjust
temperature. Allow
10-15
seconds for the adjusted
temperature to reach the
showerhead. The control knob
operates through approximately
¾ of a turn from cold to hot.
Clockwise rotation will give
warmer water with less flow.
Anticlockwise rotation will give
cooler water with more flow.
6. To turn off
the Mira Sprint press
the
stop
button. The appliance
will continue to run for a few
seconds before stopping.
7.
A small amount of water may
be retained in the showerhead
after the shower control has
been turned off. This may drain
over a few minutes.
F o r s u m m e r e c o n o m y
showering use position
ECO
(Half Power) on the control. For
a cold shower select
LOW
.
8. Switch off
pull-cord or wall
mounted switch.
=
=
=
=
=
COLD
Stop Start
Stop Start
ECO
Hotter
Press to Start/
Stop
Cooler
HIGH
LOW
Operating Instructions
Caution!
Always check the temperature before entering the shower. The previous
user may have selected a
different
temperature setting.
