Koganei DTRY-ELB01, Руководство пользователя

Страница: 2 / 20

Blow type
(For removal of static electricity with pinpoint accuracy)
■ Enables carrying ion through a tube or metal pipe, which was considered to be impossible up until now.
● Allows removal of static electricity where there is limited space to install the Ionizer body.
■ These units can be used with a low voltage DC power supply due to an in-built compact high voltage transformer.
● This eliminates high voltage wiring and power supply, leading to trouble free use caused by power supply and
wiring section.
■ Enables static electricity removal with pinpoint accuracy.
● By using an air tube or flexible metal piping, the Blow type enables quick removal of static
electricity on a targeted point due to the ability to move the nozzle closer to the point.
● Minimum distance between the nozzle and the targeted object is 1mm.
■ Due to good ion balance, removal of static electricity is always possible.
● ± 15 V range at 10 mm distance. Under some conditions, within 10 voltages
could be attainable.
● Decay time from 1000V to 100V at 100mm distance is within a second.
■ There is no electric field concentration at ion generating section,
therefore there is no detriment to the device.
● A strong electric field is generated at the high voltage applying section in
current ionizers. This can cause breakage of the device when bringing the
ionizer close. However, the Koganei Ionizer causes no damage to the
device even when bringing it close.
■ Very low generation of electrical noise due to low voltage output.
● EMI locator reacts at 1mm position from the tip of a discharging needle.
■ Alarm output when abnormality occurs in high voltage
section where generating ion.
● Ensures prevention of producing defective products caused by faulty removal of static electricity.
■ Controller is available
● The controller includes an in-line filter PLF100 and a regulator. The former removes particles and the latter adjusts
pressure, enabling control of both power supply and air for the Blow type.
Note: Ensure removal of oil and water in the air beforehand.
K q
Conductive tube holder
DTRY-NZR31
Application example
● Removal of static electricity
Low-level electric noise
(A measurement value of electric noise: 19dB
μ V/m or less at 30MHz)
・ No damage to a device caused by induction electric field from the discharging needle.
・ Removal of static electricity with pinpoint accuracy. (It is possible to bring the nozzle close to a device.)
● Removal of static electricity in a small bottle
By using pipe/tube type nozzle enables removal of static electricity inside
of a bottle necked container.
IONIZER body
(In combination with a nozzle.)
1-head type
※ When using a flexible tube
2-head type
※ When using a standard nozzle
Release of New generation's AC Ionizer!
Two types are available; the Blow type version can remove static electricity
with pinpoint accuracy, and the Fan type does not require an air supply.
As distinct from current AC type ionizers, these units can be used with a low
voltage DC power supply due to the use of a compact high voltage
transformer, which eliminates high voltage wiring.
Photo shows a
full-size.