4
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction
or break-down, grounding provides a path of least
resistance for the electric current to reduce the risk of
electric shock. This product is equipped with a cord that
includes a grounding plug. You must make sure that the
plug is inserted into an outlet that is properly installed
and grounded in accordance with all local codes and
ordinances.
Warning: Improper connection can result in a risk
of electrocution. Check with a licensed electrician if
you are unsure as to whether the outlet is properly
grounded.
DO NOT modify the plug provided with the unit; if it
will not fit the outlet, a have a proper outlet installed
by a licensed electrician. Do not use any type of
adaptor with this product.
EXTENSION CORDS
Extension cords are NOT recommended for this
product. If an extension cord must be used, the
following requirements must be met:
• 14-3 gauge minimum wire size up to 25 ft. cord. (120V)
• 12-3 gauge minimum wire size up to 50 ft. cord. (120V)
• 10-3 gauge minimum wire size up to 50 ft. cord. (240V)
• Use only 3-wire extension cords that have 3-prong
grounding type plugs and 3-pole cord connectors that
accept the plug from the unit.
Use only extension cords that are intended for outdoor
use. These extension cords are identified by the
marking “Acceptable for use with outdoor appliances;
store indoors while not in use.” Only use extension
cords with a rating no less than that of the rating of
the product. Do not use damaged extension cords.
Examine the extension cord before using and replace
if damaged.
Do not abuse the extension cord and do not yank on
any cord to disconnect. Keep cord away from heat
and sharp edges. Always disconnect the extension cord
from the receptacle before disconnecting the product
from the extension cord. If you are using an extension
cord, it should always be completely unwound.
SAFETY PRECAUTIONS
(CONT’D)
33. Securely connect the discharge lines before starting
the pump. An insecurely connected line may cause
personal injury and/or property damage.
34. To avoid serious injury and damage to the unit DO NOT
operate this pressure washer with any components
rated less than the pressure rated for each model (i.e.:
spray guns, hoses, hose couplings, etc...)
35. DO NOT allow the pressure washer to run for
more than 3 minutes with the gun closed and motor
running. Prolonged operation in bypass mode can
result in damage to the pump.
36. Shut the motor OFF if you are not using the pressure
washer.
CAUTION: The pressure has been preset by the
manufacturer. DO NOT attempt to adjust the pressure
higher than its factory setting. Doing so will damage the
pump, void the warranty and could result in personal
injury or damage.
CAUTION: This machine has been designed for use with
pressure washer detergents only.
WATER SUPPLY
(Cold Water Only)
This pressure washer must only be used with clean water;
use of unfiltered water or corrosive chemicals will damage
the pressure washer.
1.
The supply hose should be at least 5/8” in diameter.
2.
The water supply much be at least twice to the flow
rate of the pressure washer. (GPM)
3.
The water supply pressure must be a minimum of
20psi and must not exceed 120psi.
4.
The water supply temperature must not exceed
40
˚
C/104
˚
F.
5.
Never use the pressure washer to draw in water
contaminated with solvents, e.g. paint thinners,
gasoline, oil, etc.
6.
Always prevent debris from being drawn into the
unit by using a clean water source.
7.
Calcium build-up due to hard water is NOT covered
by the warranty.
IMPORTANT SAFETY PRECAUTIONS
(CONT’D)
