Kodak STEP Touch, Руководство пользователя

Страница: 19 / 22

19 | EN
Firmware Updates
When you connect to the KODAK STEP Prints app it will automatically check if there’s an update available for your
device. You’ll be prompted to perform a 2-step process: downloading and installing.
First you will be asked if you want to download the update now or later. If you press “DOWNLOAD NOW,” the download
will start and you will not be able to use your camera or turn the camera off for a few minutes until the download has
completed.
When the download has completed, you will be asked if you want to install the update. Press “INSTALL NOW” to begin
the installation process. You will not be able to use your camera or turn the camera off for a few minutes until the
installation has completed. A progress bar will show you the installation status. After the firmware update has been
installed, the camera will automatically turn off. You will have to turn the camera on again.
If you choose to delay the installation process, it will automatically begin before the camera turns off. You can also go to
settings > ABOUT to download and install firmware.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body.
14. FIRMWARE
15. COMPLIANCE