Kodak MULTILOADER 700 PLUS, Руководство по установке

Страница: 10 / 96

1
. If a PROCESSOR M6B is to be used, a PROCESSOR READY KIT (CAT. NO.
7094865) must be installed.
2
. A POWER CORD 6051531 must be ordered separately if a PROCESSOR M6B up to
SN 20000 or a 460RA up SN 1132 is installed with the SBS. This cable is needed as
an ADAPTER between CABLE 9261071 and the SAFELIGHT RECEPTACLE of the
above mentioned PROCESSORS.
SITE INSPECTION
Prior to the installation check the site for:
1
. Correct wall cut-out, if a DARK ROOM FEED TRAY (DFT) is to be used and the
availability of a large wooden WALL PLATE to make the wall cut-out light tight around
the DFT, especially if there was a PROCESSOR installed before.
NOTE
This large WALL PLATE is not provided by the factory. The customers premises are unknown to the factory.
A small SEAL PLATE for feeding the hoses and the air exhaust to the DARK ROOM will be provided by
the factory. This small SEAL PLATE makes the cut-out around the supply hoses light tight.
2
. Check that all supplies (plumbing, electrical and exhaust) are correct. 4.2 m of
SHRINKING TUBE is supplied with the SBS to make the transparent DRAIN TUBES
light tight when routed into the DARK ROOM. If FIXER MANAGER and AUTOMIXER
are to be used, additional SHRINKING TUBE is required.
NOTE
The air exhaust for the PROCESSOR must have a negative air pressure 24 hours a day.
3
. Check your local safety requirements if a separate PROCESSOR MAIN SWITCH at
the wall is necessary.
SEISMIC BRACKETS
If SEISMIC BRACKETS have to be installed due to local regulations, order the SEISMIC
BRACKET KIT Part Number 8B6586.
II 3066-2
10/98 1-6 KODAK AG, Stuttgart