Kodak MULTILOADER 700 PLUS, Руководство по установке

Страница: 49 / 96

8. SYSTEM ASSEMBLY
1
. If a DARK ROOM FEED TRAY is to be used, mount the wooden WALL PLATE now
to the wall. The purpose of this WALL PLATE is to make the wall cut-out around the
DFT light tight. Attach the provided foam coated SEAL PLATE to the wooden WALL
PLATE. The purpose of this plate is to route the hoses from the PROCESSOR into the
DARK ROOM. Only a AIR EXHAUST HOSE with 70 mm diameter can be fed
through the SEAL PLATE!
NOTE
This SEAL PLATE is provided by the factory. The wooden WALL PLATE is not provided by the factory.
The customer premises are unknown to the factory therefor this WALL PLATE cannot be provided.
2
. If no DFT is used, close the DFT OPENING at the rear of the SBS. Use the large
and the small ADHESIVE BACK DFT COVER.
3
. Move the SBS to its final position.
NOTE
If a DFT is to be used, Route the RED/GREEN LED BOX through the wall opening first. Use care to pre-
vent the wires from breaking as long as the LED BOX is not fixed to the wall.
Place the large ADHESIVE COVER
from the outside and the small ADHE-
SIVE COVER from the inside over the
DFT OPENING
figure 8-1
II 3066-2
KODAK AG, Stuttgart 8-1 10/98