INTRODUCTION
The SEISMIC BRACKETS of this KIT secure the ML700 only. The SBS itself needs no
seismic protection, for it is connected to the ML700 and to the PROCESSOR. The SEISMIC
BRACKETS for the PROCESSOR must be ordered separately. INSTALLATION NOTE To
install the SEISMIC BRACKETS the complete SBS-SYSTEM must be installed first.
1
.
Disconnect the ML700 from the SBS.
2
.
Take off the LEFT-, RIGHT- and REAR COVER of the ML700.
3
.
Move the ML700 back in its correct position, lock it to the SBS and pull out the
DRAWER approx. 6 inches.
4
.
Use SEISMIC BRACKET N0.3 as a RULER and mark the front left corner with a
FELT PEN onto the floor.
5
.
Do the same procedure for the front right corner of the ML700.
6
.
Disconnect the ML700 from the system and move it aside.
Front left corner of
the ML700
SEISMIC BRACKET No. 3
FELT PEN mark on the floor
figure 15-1
II 3066-2
10/98
15-2
KODAK AG, Stuttgart
Содержание MULTILOADER 700 PLUS
