Kodak DryView 8100, Руководство пользователя, Страница: 21 / 75

DryView 8100 Laser Imager User
2-2
8754020 2000 March Rev. B
Local Panel Functions
This paragraph describes the controls and indicators on the Local Panel. Use of
these controls is covered in Section 3. Display window messages are explained in
Section 6.
1. Power Light – Indicates that the imager is powered up.
2. Ready Light – ON: Indicates that the imager is available for printing.
– Blinking:Indicates that the imager is printing.
– OFF: Indicates that the imager is not available for printing.
3. Attention Light – Indicates an error condition that may affect imager operation
(e.g., imager warming or film low). Check the display window for a related
message.
4. Alarm Light – Indicates that an error condition exists (e.g., a film jam or open
door), and imager operation cannot continue until the error has been cleared.
Check the display window for a related message.
5. Display Window – Provides information about the status and function of the
imager and the prints in progress. Refer to Section 5 for descriptions of the
messages displayed in this window.
6. (Enter) Key – Press to enter a selected value or to return to the status and
error screen.
After you have changed the contrast or density setting, press to lock in the
new setting.
After viewing maintenance information or IP addresses on the message
display, press
to return to the status and error message screen.
7. Maintenance Information Key – Press to display a scrollable list that includes:
Maintenance information such as total lifetime print count and number of
prints remaining until preventive maintenance is required.
IP address of the imager.
Reserved service IP address.
8. Calibrate Key – Press to print a calibration test (step wedge pattern) as the next
film. (The test film will interrupt a multiple-sheet print job.)