22
Activating and deactivating the RF signal
To deactivate the RF signal
, press the ON/OFF button. The following appears
on the display panel: “
RF Mute Off?
” Then press the multi-function switch so
the “
RF Mute On?
” is displayed. Confirm. The transmission icon (4) is no longer
displayed.
To activate the RF signal
, press the ON/OFF
button until “
RF Mute On
” appears on the dis-
play panel. Then, press the multi-function switch
so “
RF Mute Off?
” is displayed. Confirm. Trans-
mission icon (4) appears on the display panel.
3. If the microphone is switched on but it does not connect to the Kolibri system, it is pos-
sible the microphone has been set at a wrong frequency or the RF signal transmission is
locked.
To
reset the frequency
, call up the “Frequency preset” menu in the menu bar by
means of a multi-function switch (11). Confirm the menu (Image 1). Choose the
correct frequency and confirm the selection (Image 2). Then, select the frequency
channel (Image 3) and confirm or store the setting. “Stored” appears on the display
panel, indicating the reset settings have been successfully stored.
CAUTION! In case you are using two wireless microphones, make sure
they are set at different frequencies, but in accordance with the in-built
receivers. Setting both microphones at the same frequencies will cause
sound disturbances!
The microphone and the in-built receiver in the Kolibri system must be
always set at the same frequency. Check the frequency stated in the
warranty certificate and adjust the microphone’s frequency, if needed.
slika 1
slika 2
slika 3
4
