Heinrichs Messtechnik GmbH
Operating Manual KDS/BGK
Page 5
2.3
Packaging, mounting and shipment
Carefully unpack the device to avoid damaging it.
With the help of the delivery note enclosed in the packaging, check whether all technically relevant data coincide
with your requirements.
Storage and installation must be done in a clean and dry room so that contamination – especially of the interior
of the fitting – is avoided. Follow the limit values for ambient temperature. When transporting the device to a
remote mounting location, we recommend that you reuse the factory-issued packaging and the transport
protection.
2.4
Returning devices for repair and service
Note: In accordance with the applicable German waste disposal legislation, the owner/client is responsible for
the disposal of special waste and hazardous materials. Consequently, all devices sent to us for repair must be
free of any hazardous materials. This also applies to possible hollow spaces and fissures in the devices. If repair
is necessary, confirm the above-mentioned item in writing.
(For this purpose, please use the form in the Section Fehler! Verweisquelle konnte nicht gefunden werden. ).
If hazardous materials remain in or on the device after it has been returned, Heinrichs Messtechnik is authorized
to remove them at the client’s expense without further inquiry.
