Kobold DSS -11, Руководство по эксплуатации, Страница: 5 / 36

DSS
DSS K08/0322 Page 5
6. Mechanical Connection
Before installation

Make sure that the max. allowed operating pressures and service
temperatures are not exceeded

(see standard material combinations).

The instrument is fitted vertically in the piping. Flow is from bottom to top
(vertical dial).

Remove all transport restraints and make sure that none of the packing
remains in the instrument.

Use Teflon tape or something similar to seal the screw connections.

The instruments should not be installed in an induction field.

If possible, check after mechanical installation that the threaded joint/pipe
connection is tight (see section 9. Commissioning).
7. Electrical Connection
7.1. Plug Connection

Make sure that the electrical supply wires are de-energized.

Undo the locking screw on the plug cap and remove the cap
from the base.

Mount supply line in the plug cap as shown in the wiring
diagram.

If the contact has not been adjusted, adjust it now (see
section 9. Commissioning).

Insert the plug connector to the contact stem and fix it with
the retaining screw. (see section 9. Commissioning)