7
ASSEMBLY AND ADJUSTMENTS
Estimated Assembly Time: 25-40 Minutes.
INSTALLING THE STAND (FIG. A)
1. Unpack all parts and group by type and size. Refer to the
table of loose parts list on page 5 for correct quantities.
2.
Bag “F” & “H” -
Attach one leg of front bracket - upper
support (1) to top of leg, marked “F” (2) using one
bolt (3) and nut (4). The stand leg is placed on
the outside of the brackets.
NOTE:
• The left side of the bracket has only one hole and
the right side has two holes.
• Only hand tighten at this point. Do not tighten bolts
with a wrench until stand is properly aligned
(see step #8 before tightening).
• The front and rear stand legs are different in angles
and cannot be mixed. The two front stand legs are
marked with a “F” and the two rear stand legs are
marked with a “R”.
3. Attach other end of front bracket - upper support (1) to
top of another leg (2) using two bolts (3) and nuts (4).
4. Attach the front bracket - lower support (5) to center
the two legs using bolt (3) and nut (4). This completes
the front frame section.
5.
Bag “E” & “H” -
Assemble rear frame section in exactly
the same manner using the shorter rear brackets (13 & 14).
6.
Bag “C” & “D” -
Join the front and rear frame sections
using two brackets upper supports (6) and two lower
supports (7) with bolts and nuts.
7.
Bag “G” -
Place the four foot pads (8) into the bottom
of each leg, lightly use a rubber mallet if needed.
NOTE:
The foot pads for the front stand legs and the rear
stand legs are different and cannot be mixed. The two
larger foot pads are marked (F) and must be placed on
the front stand legs. The two smaller foot pads are
marked (R) and must be placed on the rear stand legs.
8. Place the stand on level surface, adjust all legs to contact
and are at similar angles to the floor. Tighten all bolts.
NOTE:
To avoid rocking, all bolts must be tightened
securely using a 13 mm or adjustable wrench.
WARNING
• The stand is designed only for use with
a scroll saw.
• Do not climb, sit or stand on the stand assembly.
• Do not use the stand on uneven or unstable surface.
• To avoid injury, do not connect this scroll saw
to the power source until it is completely assembled
and adjusted and you have read and understood this
instruction manual.
9
4
1
3
2 (F)
8 (F)
7
8 (R)
6
5
10
12
11
13
14
2 (R)
Front side of
frame assembly
MOUNTING THE SCROLL SAW (FIG. B)
1. To mount your scroll saw to the stand, position
the assembled stand on a firm, level surface.
2. Line up the four holes (15) on the scroll saw base with
the holes in the stand leg, place the scroll saw on
the stand.
3. Secure the saw to the two mounting holes in the front of
the stand using the two hex bolts (9), two flat washers
(10), two sleeves (11) and two nuts (12) provided.
4. Secure the saw to the two mounting holes in the rear of
the stand using the two hex bolts (9), two flat washers
(10) and two nuts (12) provided.
NOTE:
No sleeves (11) are used for these two mounting
holes.
5. Tighten all four nuts using two 13 mm or adjustable
wrenches.
NOTE:
Do not over tighten nuts, it may damage the saw
base.
12
15
10
9
11
10
9
15
12
Fig. A
Fig. B
Front
