KNOVA KN M-2502N, Руководство пользователя

Страница: 18 / 53

Fig. KK
2
3
4
1
17
OPERATION
SLIDE CUTTING WIDE BOARDS UP TO 12 IN. WIDE (FIG. KK)
To avoid injury:
• Never pull the cutting head assembly and spinning blade
toward you during the cut. The blade may try to climb up
on the top of the workpiece, causing the cutting assembly
and spinning blade to kick back, forcefully. The cutting
head assembly should be drawn back completely then
pushed forward when sawing.
• Let the blade reach full speed before cutting. This will help
reduce the risk of a thrown workpiece.
To Slide Cut Wide Boards (Fig. KK)
1. Unlock the carriage lock handle (1) and allow the cutting
head assembly to move freely.
2. Set both the desired bevel angle and/or the miter angle
and lock into position.
3. Use a hold down clamp to secure the workpiece.
4. Grasp the switch handle (2) and pull the carriage (3)
forward until the center of the saw blade is over the front
of the workpiece (4).
5. Engage the trigger to turn the saw on.
6. When the saw
reaches full
speed, push the
switch handle
down, slowly,
cutting through
the leading edge
of the workpiece.
7. Slowly move the saw
handle back toward the
fence, completing the cut.
8. Release
the
trigger and
allow the blade
to stop spinning
before allowing
the cutting head
to raise.
2
1
33.9° BEVEL STOP FOR
CROWN MOLDING (FIG. II)
1. Push the bevel detent stop
pin (2) in toward the front
of the machine.
2. Loosen the bevel lock handle (1).
3. Rotate the cutting head
until the bevel detent
pin stops the bevel
angle at 33.9° on
the bevel scale.
4. Tighten the bevel lock handle
before making a cut.
COMPOUND CUT (FIG. JJ)
A compound cut is the combination of a miter and a bevel cut
simultaneously.
1. Loosen the bevel lock handle (1) and position the cutting
head at the desired bevel position. Lock the bevel lock
handle.
2. Loosen the miter handle (2). Lift up the positive stop
locking lever (3) and position the table at the desired angle.
Release the positive stop locking lever (3) and lock the
miter handle
(2).
Fig. JJ
1
2
3
Fig. LL
2
1
CUTTING GROOVES (FIG. LL)
1. Mark lines identifying the width and depth of the desired
cut on the workpiece and position on the table so the
inside tip of the blade is positioned on the line. Use a
clamp to secure the workpiece.
2. Lower the cutting head so the tip of the blade touches
the top surface workpiece at the marked line.
3. While holding the upper arm in position, turn the stop knob
(1) until it touches the stop plate (2).
4. Cut two parallel grooves as shown below.
Cut these
grooves with saw
Use a chisel to cut
out the middle
1
2
Fig. HH
Fig. II
WARNING
Only use the miter saw to make a crosscut
on metals. Never use it to make miter cutting, bevel
cutting or compound cutting on metals.
WARNING
Never use the miter saw to cut grooves
on metals.