KNOVA KN BTS-10W, Руководство пользователя

Страница: 10 / 51

ASSEMBLY
MOUNTING SAW TO ALTERNATIVE BASE (FIG. 3)
1. This saw MUST be properly secured to a sturdy workbench,
stand or cabinet. Use the four 3/8 in. holes already provided
in the saw base. The front two holes (1) are shown in Fig. 3.
There are two additional holes in the rear of the saw base.
9
WHEN NOT USING SAW ON THE STAND, PROVIDE A SAW-
DUST CUTOUT IN THE WORK SURFACE.
ASSEMBLE BLADE ELEVATION/TILTING
HANDWHEEL (FIG. 4)
1. Attach blade elevation and tilting handwheel (1) to the
height regulating bolt (2). Make sure the slot (3) in the hand-
wheel hub is engaged with the roll pin (4) in the height regu-
lating bolt.
2. Fasten handwheel to height regulating bolt with flat washer
(5) and dome nut (6).
RIP FENCE (FIG. 5)
1. Lift up on the rip fence handle (1) so the rear fence clamp
(2) is fully extended.
2. Place the rip fence on the saw table and push down on the
rip fence handle (1) to lock.
CAUTION
Do not operate this Table Saw on a flat surface with-
out first cutting a hole 12 in. square under the saw to
allow sawdust to fall through and be removed. Fail-
ure to provide this sawdust removal hole will cause
sawdust to build up around the motor which could
result in a fire hazard or cause damage to the motor.
Unplug unit from power source before attempting any
sawdust removal.
Fig. 3
Fig. 4
Fig. 5
INSTALLING AND CHANGING THE BLADE (FIG. 6, 7, 8)
CAUTION
• To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
not connected to the power source outlet.
• To avoid serious injury, the rear of the table insert
must be level with the table. A rubber adjusting
spacer is provided under the rear of the insert for
this purpose. If the rear of the table insert is not
level with the rear of the table, adjust the screw (3)
until it is level with the table. To raise the insert,
turn the screw counterclockwise. To lower the
insert, turn the screw clockwise.
NOTE: The front of the insert is stationary and non-adjustable.
1. Remove the table insert (1) by unscrewing the two screws
(2, 3). Be careful not to lose the rubber washer that is on the
back screw (3) beneath the table insert. (Fig. 6)
Fig. 6