KNOVA KN BD-46B, Руководство пользователя

Страница: 7 / 29

6
ASSEMBLY
On the smooth side of the sanding belt, there is a directional
arrow. The sanding belt must run in the direction of the arrow.
• Using the hex key provided, loosen the positioning bolt
by turning the bolt counterclockwise.
• Move the sanding belt into a vertical position.
• Lock the sanding belt by retightening the positioning bolt.
• Pull the belt tension lever toward you to release the belt
tension.
• Place the sanding belt over the drive roller and idler roller
with the directional arrows running counterclockwise. Be
sure the sanding belt is centered on both drums.
• Push the belt tension lever back into place to apply the
belt tension.
NOTE: The belt tension lever is spring loaded; use extreme
caution when pushing the tension lever back into place to
avoid personal injury.
Fig. 7
Fig. 8
MOUNTING THE WORK TABLE FOR USE WITH
THE DISC SANDER
MOUNTING THE WORK TABLE FOR USE WITH
THE BELT SANDER
ASSEMBLING WORK SUPPORT
• Insert the work table index pin into the hole in the tool’s
housing.
• Position a washer over the table lock knob then tighten
the table lock knob securely.
• Insert the work table index pin into the hole in the sanding
belt arm.
• Position a washer over the table lock knob then tighten
the table lock knob securely.
• Place the work support over the holes in the side of the
sanding belt arm.
• Using a hex key, fasten in place with washers and socket
head screws.
C
INSTALLING/REPLACING SANDING BELT
Fig. 5
Drive roller
Sanding
belt
Table
lock
knob
Socket
head
screws
Work
table
Washer
Work support
Washers
Index pin
Table
lock knob
Index pin
Work table
Washer
Directional
arrow
Positioning
bolt
Idler roller
Belt
tension
lever
Fig. 6