Page 6 of 16
0900934 Rev: REL (05/09)
•
Continued
*** DISPENSER ***
MEMORY FUNCTIONS
1
This menu selection is used to load factory default settings:
– Unit of measure is set to US
– Continuous batching set to zero (off)
– Simultaneous pump setting is turned OFF
– Card reader access is turned off
– All user codes are set to zero / user names are reset
– Report name is cleared (blanked out)
– Chemical names and formula names are reset
– Shift start times are reset: 1 = 06:00 / 2 = 11:00 / 3 = 17:00
– Operating zone is set for 00:00 to 24:00
Press YES to begin restoring default settings (also known as
“clearing the setup“) or press NO to move on to the next menu
selection without restoring defaults.
RESTORE DEFAULT SETTINGS ?
PRESS: YES OR NO
NO
NO
NO
NO
YES
YES
YES
YES
You are then asked if you really do want to use this
command. Press YES if you are sure, or press NO to
move on to the next menu selection without loading.
This message indicates that the clearing
process is active (factory defaults are being
loaded at this point). When the process is
complete, the next menu item will appear.
CLEARING SETUP
*** PLEASE STAND BY ***
ARE YOU SURE ?
PRESS: YES OR NO
YES
YES
YES
YES
NO
NO
NO
NO
GO TO NEXT PAGE
This menu selection is used to zero out the batch count (this is the
digital counter that appears on the screen when pressing the
BATCH COUNT button on the control panel). Press YES to begin
clearing, or press NO to move on to the next menu selection
without clearing.
CLEAR BATCH COUNT ?
PRESS: YES OR NO
NO
NO
NO
NO
YES
YES
YES
YES
This message indicates that the clearing process is
active. When the process is complete, the next menu
item will appear.
CLEARING BATCH COUNT
