0900934 Rev: REL (05/09)
Page 9 of 16
SETUP ROUTINES MENU HEADING
•
Continued
*** DISPENSER ***
SETUP ROUTINES
2
This menu selection allows you to change the unit of measure.
Use the number buttons to choose the desired unit of measure.
Press the MENU
button to continue.
UNIT OF MEASURE = US
1=US 2=METRIC 3=IMPERIAL
This menu selection is used to setup the continuous batching
feature. The number of users can only be from 1 to the number
you specify. For example, you cannot select users 25 to 40 only.
The number of seconds is the time frame allowed from the end of
one batch to the start of another without having to re-enter the
user code. For example if you entered 30 seconds, then those
users would be able to dispense batches continuously providing
that 30 seconds is not exceeded between batches.
Use the number buttons to enter your settings, then press
ENTER. A setting of user 1 to 000 turns this setting off (disable).
Press the MENU
button to continue.
CONTINUOUS BATCHING
USER 1 TO 00 000 SEC
This menu selection allows you to choose if you want all pumps in
a formula to run at the same time. When this selection is off, all
pumps in the formula will run in sequence from left to right (lowest
number to highest). Use the number buttons to make your
selection. Press the MENU
button to continue.
SIMULTANEOUS PUMPS = OFF
1=OFF 2=ON
This menu selection tells the system which water valves will be
used. This prevents manual activation of any water flush valves
that will not be used. Choose 0 if no flush, 1 if only using output
11, or 2 if using both outputs 9 and 10, then press ENTER. Press
the MENU
button to continue.
NOTE: Make sure you enter 1 if you are only using one flush.
NUMBER OF WATER VALVES = 2
THEN PRESS ENTER
This menu selection tells the system if a card reader will be used.
When using a card reader, user codes are 8 digits long. The 8
digit code can be entered at the keypad if necessary (I.e.
someone lost their card) however defeats the convenience of
having a card.
If not using a card reader, then user codes are 3 digits long and
must be entered at the keypad. Use the number buttons to make
your selection. Press the MENU
button to return to the menu
heading.
CARD READER ACCESS = OFF
1=OFF 2=ON
