KNEGT 404G2 Series, Руководство по эксплуатации

Страница: 55 / 105

404G2
SERIES TRACTOR OPERATION MANUAL
53
implement when the tractor stops. The speed of PTO changed by PTO control handle (as
shown in figure 4-20).
The control steps of the power output shaft are as follows:
(1) Put the PTO control handle in neutral position.
(2) Remove the protective cover on the power output shaft and firmly connect the power
output shaft with the farm implement after confirming that the power output shaft is no
longer rotating.
(3) Pedal the clutch pedal to the bottom, then turn the PTO control handle to the engage
position, slowly release the clutch pedal, and the power output shaft can drive the relevant
parts of the farm tools. The power output shaft shall be operated at a low speed, and the
connection and operation of the farm implement shall be checked, and the normal operation
shall be carried out after confirmation.
Using a power output shaft, farm implements hoisting height should be determined by the
angle between the power output shaft with implement, the angle no more than 20
°
is
advisable.
WARMING
(1) When the power output shaft is not used, the PTO control handle shall be placed in
neutral position and two protective shields shall be installed.
(2) The driving type farm implement shall have the same input speed with power output
shaft output speed, otherwise the operation quality will be affected, and even the early
damage of the tractor and the machine will be caused.
4.3.6 Ballast
The tractor traction consisting of tractors power, and operation condition of the soil or road
has been set, so the main factors affecting the traction force play is the tractor quality and
the quality distribution of the front and rear wheels. The tractor must have a proper quality
to play as soon as possible. The use of ballast should consider the load capacity of the tire
and the maximum allowable quality of the tractor.