Knauer WellChrom K-2600, Руководство пользователя

Страница: 20 / 68

20 Operating the Photometer
Load Edit Prog Events: 2 Signal 1 Signal 2
Prog Clear 0 off 0 on 1 [au] [au]
01 07 00 .--- .---
ON 000.0 254 280
Hold 0 Time λ 1 λ 2
Run 1 [min] [nm] [nm]
Link
View
Setup
GLP
Load Edit Prog Events: 2 Signal 1 Signal 2
Prog Clear 0 off 0 on 1 [au] [au]
01 07 10 .--- .---
ON 005.0 254 280
Hold 0 Time
λ
1
λ
2
Run 1 [min] [nm] [nm]
Link
View
Setup
GLP
Load Edit Prog Events: 2 Signal 1 Signal 2
Prog Clear 0 off 0 on 1 [au] [au]
01 07 00 .--- .---
ON 010.0 254 280
Hold 0 Time
λ
1
λ
2
Run 1 [min] [nm] [nm]
Link
View
Setup
GLP
A
B
C
Fig. 17 Programming steps for example program no. 7
Execution of the program can either be continued by pressing 1 and
returning to RUN again or it can be stopped by pressing 0 again. If you
stop program execution the instrument will return to the parameters of
the start time. These initial parameters are activated also after a
program run is finished.
A program can also be started via input START IN on the rear panel of
the instrument. In case a trigger signal is applied to this input, the
system switches into mode
RUN .
Creating Program Links
Program links are cross references to existing programs, which can be
defined and edited similar to programs themselves. Links cannot
reference other links.
In the editing mode links are defined and loaded as the reserved
program numbers 21 to 29, where program 21= L1, 22 = L2 etc.
Links have line numbers from No. 01 up to No. 99 , every line containing
one program, one number for repetitions and a wait-status
programmable. The K–2600 UV detector can store up to 9 different
links, but the maximum number of programs used in all links is limited to
100. Each program may appear in any frequency in any link.
Programming a link
Enter the number of the desired link in the field Edit Prog, for example
22 for link L2 and press any arrow key to confirm. Part A in Fig. 18 is
showing that step, the cursor blinking at
No** . Now press any numeric
key to generate a new, continuously numbered line. In this case No01
will appear.
Then use
⊲
to move the cursor to P -field and choose the desired
program number, e.g. 03. Press again
⊲
to put in at the R -field the
number of runs to be performed with the selected program, e.g. 05.