KMD-5205 and KMD-5270 Installation and Operation
Revision J
Operating the controller
Resetting the controller
25
Resetting the
controller
Use the reset button for either of the following functions.
◆
Restore the modem settings.
◆
Restore all configuration settings to the factory default settings.
Caution
Restoring the controller erases all programs and point configuration. Connect
to the controller through Ethernet or a dial-up modem and use either
WinControl XL Plus or TotalControl to save the programming in a panel file
before resetting the controller.
To restore only the modem settings
A controller that has been set for modem operation with HCM cannot directly
connect to a computer at the RS–232 port unless it is changed with the reset
button.
To change the controller from modem connection to direct computer connection
do the following:
1. Remove the plastic cover surrounding the six LEDs.
2. Press the reset button for one second and then release it.
Restoring to factory settings
Restoring a controller to factory settings changes the controller as follows:
◆
Removes all programming.
◆
Removes all configuration settings.
◆
Restores the controller to factory default settings.
Caution
Resetting the controller erases all configuration and programming. After
resetting to factory settings, you must configure and program the controller to
establish normal communications and operation.
To reset the controller to factory settings.
1. If possible, use WinControl XL Plus or TotalControl Design Studio to
backup the controller.
2. Remove the plastic cover surrounding the six LEDs.
3. Remove the power jumper. See the illustration
4. Press and hold the red restart button.
5. Replace the power jumper while continuing to hold the restart button.
6. Release the restart button when the SUBLAN and PC LEDs illuminate.
