Instruction Manual
IDO
8065
-HILO
8065
09/01/19 Rev: 1.0. 0 (TRANSLATION OF ORIGINAL LANGUAGE)
25
12.3. Double washing and single drying
Particularly dirty floors may not be sufficiently cleaned with one pass. In these cases double brushing
must be performed.
To perform double scrubbing and washing, make a first pass with lifted wiper, manually lifting it and
locking it with the magnets.
In this way the solution is in contact with the floor while the brushes work to reduce the layer of dirt.
Leave a reasonable length of time elapse so that the solution is sufficiently in contact with the floor. The
length of time elapsed between the first and second pass depends on the amount of dirt and type of
chemical used.
A second pass with wiper and brushes lowered and activated solution further reduces the layer of dirt. A
further application of solution contributes to making a hard cleaning operation mush easier.
12.4. Emptying and cleaning the recovery tank
1 - Place the vehicle near a manhole drain. The discharge pipe is at the rear of the machine.
4. Remove the drain hose from the hook. Unscrew the cap and lower the drain hose towards the floor
drain. Stay behind the end of the pipe. Lock the filthy water by pressing the rubber; remove the cap from
the drain hose slowly. The recovered solution escapes with adjustable pressure from the rubber hose
mentioned above.
5. Open the upper tank cover.
6. Wash the recovery tank with clean water. Repeat washing until clean water issues from the discharge
pipe. Do not use water at temperature higher than 50°C as it might damage the tank.
7. Replace the cap and the discharge pipe.
8. If the machine must be left inactive for a long period of time do not close the recovery tank upper cover
and the drain hose cap, to allow air to circulate inside it.
