22
www.klindex.com - Made in Italy
SAFETY DEVICES OF THE APPLIANCE
Control button panel
– Press the emergency button on the control panel,
the blue reset LED activates while the green LED
stays on
– to start the appliance again, first of all restore the
emergency button of the control panel, the blue
reset LED deactivates. Then select the direction of
rotation of the planetary passing through the stop
position.
l
NOTICE
The emergency buttons must not be used
to stop the appliance in normal conditions
of use. They must only be used in the
event of a hazard or malfunctions.
7.3.2 Verification of the emergency buttons
To check operation of the emergency buttons, act as
follows:
– check that none of the emergency buttons on the
appliance is pressed by turning them in a clockwise
direction
– turn the main dial on the electric panel to the left
and set it to "1" (Transport mode). The green "PLC
ready" light and the "Transport mode" light on the
electric panel will both activate.
OFF
2
1
a
WARNING
The appliance is in operation during the
emergency button check. Pay careful at-
tention.
Button on the electric panel
– Press the emergency button on the electric panel
and check that the emergency button starts flash-
ing. If the appliance is moving, or if it is in operation,
it will stop
– release the emergency button by turning it to the
right and check that the emergency button stops
flashing.
Radio control button
– Press the reset button once. The green TX LED im-
mediately starts to flash. The yellow battery/alarm
LED flashes just once. After a few seconds the blue
RX LED starts to flash
– press the reset button a second time after the blue
RX LED has started flashing. The green TX LED stops
flashing and stays fixed on. The yellow LED stays off.
The blue RX LED stops flashing and stays fixed on
ON
TX
RX
W
W
ON
TX
RX
W
W
– the radio control is now fully operational
– press the emergency button, the radio control
switches off. If the appliance is moving, or if it is in
operation, it will stop
STOP
– release the emergency button by turning it to the
right
– reactivate the radio control following the procedure
indicated previously.
STOP
