Photo 3 – Slide the rear mount plate/bolt assemblies
over the beam. Work from the driver’s side and slide
the assemblies towards the passenger’s side
Photo 4 – All three rear mount plate/bolt assemblies in
place.
2.
Position the bracket in front of the beam, then align the rear mount/bolt assemblies so that
the bolts pass through the mounting holes in the bracket. Hand tighten the six Nyloc nuts
onto the bolts.
3.
Position the entire bracket assembly towards the passenger side of the beam. There is a
welded joint at the end of the beam – the bracket should be butted up against that weld.
Do not try to attach the bracket over the weld
(see photos 5 & 6)
4.
Using an 11mm gear wrench or a ratchet with a 6” extension, tighten the six Nyloc nuts.
Alternate between top and bottom so that the rear mount plates sit flush against the back
of the beam and the bolts sit flush on the top and bottom of the beam. Use a wrench to
hold the bolt heads while tightening.
5.
Attach a short section (approx 12-18”) of the black tubing in the compressor accessory
package to the air intake on the front of the compressor. Route the other end into the
existing opening in the floor brace just above the compressor.
Photo 5 – Compressor on mounting bracket, as seen
from the front of the vehicle.
Photo 6 – Mounting bracket, as seen from underneath.
