GMTRK-3
Install Guide
This Install Guide Replaces the
GMTRK-1 Installation Manual
REV: B (09/07/2022)
37
12
Routine Maintenance
Perform following maintenance at least once during recommended intervals:
1.
Yearly, or every 12,000 miles, verify all mounting fasteners are properly torqued. Applying witness marks
across fasteners and mounting parts is good practice to quickly ensure fasteners have not moved.
2.
Yearly, or every 12,000 miles,
inspect OE wiring, tubing, cables, etc.
where kit parts may touch to
verify
no abrasion or rubbing.
3.
Yearly, or every 12,000 miles, remove all road grime and mud from the mounting brackets and kit parts
using clean water from a garden hose. Pay special attention to corners where dirt may collect. Touch up
all paint chips using automotive grade enamel in either spray or brush form.
NOTE
: Do this more frequently if traveling regularly off-road, or in winter climates with road salts.
High-pressure washers
may damage part finishes and must be used with care.
4.
Yearly, or every 12,000 miles, check electrical connections, wires, and air fittings for abrasion, corrosion,
or other damage. Replace damaged components.
NOTE
: if system runs continuously or turns on unexpectedly, leaks or a poor electrical connection may be present.
5.
Monthly, or every 10 hours of compressor run time, drain moisture from the air tank using the drain valve
installed at the bottom of the tank.
WARNING:
Failure to regularly drain the air tank may result in corrosion inside the tank and possible failure in the tank or
air tubing, causing injury.
6.
Yearly, or every 12,000 miles, clean or replace the air compressor air filter element. Replacement
frequency depends on operating frequency and conditions of environment (i.e., daily use requires more
frequent changes). Order replacement filters at
NOTE
: NEVER lubricate or add liquids to the compressor.
END OF SECTION
