GMTRK-3
Install Guide
This Install Guide Replaces the
GMTRK-1 Installation Manual
REV: B (09/07/2022)
31
Figure 28- Accessible Hole Locations
2.
Remove the noted bolts from the aux. battery tray. The below figure illustrates some options
regarding bolt accessibility from the various configurations of this kit. Use any pattern that
works for your situation.
Figure 29- Mounting Options, Tank/Compressor Assembly
3.
Install the Tank/Compressor Assembly onto the aux. battery tray using hardware H7 & H8 to
replace the bolts removed from the previous step, as shown in the below figure. Fully tighten
the hardware and torque to OEM specifications.
Figure 30- Tank/Compressor Assembly Installed, Red Configuration (Left) & Blue Configuration (Right)
4.
At this time, install Item No. 6 (Pressure Switch) if it was not installed previously. Be sure to
follow guidelines for installation of NPT fittings in Section 6.
5.
Attach & route the compressor air inlet hose/filter to any suitable location. It is recommended
to place the air filter in an area that receives clean, dry air.
