Page
V 2.0
25
FAULT
POSSIBLE CAUSE
SOLUTION
Uneven flame pattern or
slight flame lifting.
Burner ports blocked.
Remove, clean and replace burner.
At minimum flame setting
the flame is too high.
Turndown control setting incorrect.
Call authorised representative.
Small flame on High
setting.
Regulator faulty.
Call authorised representative.
Gas supply pressure low.
Call authorised representative.
Incorrect injector fitted.
Call authorised representative.
Blocked injector or gas supply tube.
Call authorised representative.
Incorrect utensil size.
Refer to operating instructions utensil
choice.
Flame too high on High
setting.
Regulator faulty.
Call authorised representative.
Incorrect injector fitted.
Call authorised representative.
Incorrect utensil size.
Refer to operating instructions utensil
choice.
Disassembly of the worktop must only be done by a qualified service technician.
In case it is necessary to repair or replace the inside components, follow the instruction
below:
Remove the trivets, remove the burner caps and rings, unscrew visible screws and
nozzles.
Disassemble the worktop by unscrewing the rear screws. In this way it is possible to lift
the worktop and to reach the inside components.
Warning:
Dear Customer,
To protect the surrounding furniture cabinets, after cooking is completed, the cooling fan
may stay on until the oven has cooled down sufficiently. If you have had the oven on for
hours at a time, this fan might stay on for up to 60 minutes after you turn off the oven.
