Kittec CB Series, Руководство пользователя

Страница: 17 / 24

17
7 Troubleshooting
What
if…
… the error „E“ is displayed on the electronic
controller?
The regulation found an error in the program sequence.
The meaning of the detected error and its correction are
described in the controller user manual.
… the firing chamber does not heat up?
It might be the case that the lid or door may not be closed
completely.
… the firing chamber heats up too slowly or the kiln
does not reach the set temperature?
One or more heating elements might be damaged. First
check the elements visually for breakage or cracks. If you
cannot find any breakage, get a resistance check of the
heating elements. Broken heating elements can only be
changed by a service engineer.
Alternatively:
The voltage supply to your kiln could be below 230V. This
can be checked by your service engineer.
… the glaze did not melt out or the kiln switched off
before reaching the set temperature?
Power failure during the firing.
Alternatively:
The lid or door was not closed correctly.