9
Assembling Your Bowl Lift Mixer
To Attach Bowl
1. Be sure speed control is OFF and
stand mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Fit bowl supports over locating
pins.
4. Press down on back of bowl
until bowl pin snaps into spring
latch.
5. Raise bowl before mixing.
6. Plug into a grounded 3 prong
outlet.
To Raise Bowl
1. Rotate handle to straight-up
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate handle back and down.
To Remove Bowl
1. Be sure speed control is OFF and
stand mixer is unplugged.
2. Place bowl lift handle in down
position
3. Remove flat beater, wire whip,
or dough hook.
4. Grasp bowl handle and lift
straight up and off locating pins.
To Attach Flat Beater, Wire Whip,
or Dough Hook
1. Slide speed control to OFF and
unplug.
2. Slip flat beater on beater shaft.
3. Turn beater to left, hooking
beater over the pin on shaft.
4. Plug into a grounded 3 prong
outlet.
To Remove Flat Beater, Wire
Whip, Or Dough Hook
1. Slide speed control to OFF and
unplug.
2. Press beater upward and turn
right.
3. Pull beater from beater shaft.
Household Stand Mixer
Speed Control
Plug into a grounded 3 prong
outlet. Speed control lever should
always be set on lowest speed for
starting, then gradually moved to
desired higher speed to avoid
splashing ingredients out of bowl.
See the “Speed Control Guide”
section.
Auto-Reset Motor Protection
If the stand mixer stops due to
overload, slide the speed control
lever to OFF. After a few minutes,
the stand mixer will automatically
reset. Slide the Speed Control Lever
to the desired speed and continue
mixing.
If the unit does not restart, see the
“Troubleshooting Problems”
section.
PIN
OFF/0
STIR
RESET
RAISE
Содержание KB26G1X
Страница 1: ...5 6 QUART STAND MIXER INSTRUCTIONS AND RECIPES 1 800 541 6390 Details Inside 9707946B ...
Страница 85: ......
Страница 86: ......
Страница 87: ......