20
21
Step3: After installation, there is side protection
on the side of the door.
2.、Three-point car seat belt
Step 1 :withdraw support leg into storage
of base .
bottom view
Removing cover
Step 1 Remove inner padded pillow and
shoulder protector (Picture 1)
Remove head rest cover (FIG. 2) : guide
the tension at the hook
When the belt is detached, take off the
cloth cover.
Remove the cloth cover of the chair body
(Figure 3) : buckle the latch of the chair
body Open, take off the cloth cover.
Maintenance
Washing instructions
1.When not using the baby car seat, keep it in a dry and ventilated place to avoid damp and mold.
2. If dust is found on the seat surface, clean the safety belt, fabric and plastic parts with a damp
sponge and then air dry.
3.If accidentally drip food or drink onto the safety belt, remove the safety belt and rinse it with
warm water, then air it to dry.
4.If clean the entire cover, refer to the washing instructions
5.During the first washing, slight fading may occur, which is a normal phenomenon
Do not use solvents, chemical cleaners or lubricants on any part of this product.
Hand washable,
water temperature
below 30℃
Do not bleach
Do not dry
Do not iron
click
Step 2: put a child in baby car seat, adjust
headrest to the right position, place the
upper end of the car seat belt diagonally
through the guide hook slot at the bottom
of the head,the lower end of the diagonal
band passes through the corresponding
guide mark,the cross band passes through
two left and right guide barbs, finally, the
car latch is attached to the car buckle,when
you hear "click," it means to lock correctly,
the pelvis should be properly restrained
when the belt is worn.
Don t use force-bearing points without marking
Don't use support leg when use adult safety belt