KISSBOX CM-MIDI, Руководство пользователя

Страница: 12 / 33

indicates that the CM-MIDI is performing a factory reset.
2.1.1.3 - ACTIVITY LED
The “ACT” LED reports activity on the Ethernet network. This LED blinks shortly when a telegram is being
received by the CM-MIDI from the network.
2.1.1.4 - LINK LED
The “LINK” LED indicates that a valid Ethernet signal is being received by the CM-MIDI. This LED must be on
each time the CM-MIDI is connected to a network switch or to a computer. If this LED is off, the CM-MIDI is unable
to exchange data with any other device on the network.
If the LINK LED switches continuously between on and off states, it means that the Ethernet signal quality is
not good (broken cable or connector). Verify the network cable between the CM-MIDI and the network switch.
2.1.1.5 - Mode control push-button
The control push-button is hidden behind the small hole on the front panel. This button is used to activate
special operating modes and to reset the CM-MIDI. Access to the button is possible only using a small screwdriver
or a pen tip to avoid any accidental action.
2.1.1.5.1 - Normal reset
If you press shortly (less than 5 seconds) the push-button, the CM-MIDI performs a soft reset and restarts
as if power has been applied.
2.1.1.5.2 - Factory reset
If you press and hold the push-button until the blue LED stops blinking (button depressed for more than 5
seconds), the CM-MIDI will perform a factory reset. All operating parameters are reset to default values:
•
IP address = 192.168.0.253
•
Subnet mask = 255.255.255.0
•
Gateway address = 192.168.0.1
•
Session names are reset to default names
•
Session initiators are deactivated on each RTP-MIDI endpoint
The CM-MIDI will restart with those parameters as soon as the push-button is released
2.1.1.5.3 - Bootloader activation
The bootloader mode is used to upload a new firmware in the CM-MIDI program memory. To activate the
bootloader:
•
Disconnect power supply
•
Press and hold the push-button depressed with a tool or a pen tip
•
Connect power supply and wait until the RUN LED starts blinking fast
•
Release the push-button
To exit the bootloader mode, simply restart the CM-MIDI by removing the power supply cable.
Firmware upgrade instructions are given directly by the KissBox Editor and RTP-MIDI Editor tools (menu
“Tools / Firmware Upgrade”
Page 12 of 33