KISSBOX CM-MIDI, Руководство пользователя

Страница: 11 / 33

2 - Installing and configuring the CM-MIDI
2.1 - The CM-MIDI module
The CM-MIDI is a ruggedized module, enclosed in an aluminium alloy cabinet. It is designed to be used in
any environment, even harsh ones, like a stage during a tour.
It provides two independent RTP-MIDI endpoints, each of them supporting session initiator functionnality.
2.1.1 - Front panel
You will find the following connectors, indicators and controls on the CM-MIDI front panel:
•
RJ-45 Ethernet network connector (1)
•
RUN LED (2)
•
Activity LED (3)
•
LINK LED (4)
•
Push-button (located behind the hole on front panel) (5)
2.1.1.1 - Ethernet connector
The RJ-45 Ethernet connector is used to connect the CM-MIDI to a network switch. You can use a “direct” or
“crossed” network cable. The CM-MIDI can also be connected directly to a computer if necessary.
2.1.1.2 - RUN LED
The “RUN” LED indicates the status of the CM-MIDI firmware:
•
LED blinks every second (slow blink) : normal firmware operation. The RTP-MIDI services are available.
•
LED blinks five times per second (rapid blink) : bootloader mode. The RTP-MIDI firmware is not running
and RTP-MIDI services are not available. This mode is used for firmware upgrade.
•
Slow short flashes : if the RUN LED makes short flashes every second, it means that the firmware has
detected a problem. Restart the CM-MIDI (simply disconnect and reconnect the power supply). If the
problem is still visible after reset, contact KissBox support to get assistance
•
LED constantly ON : this shall occur only when the push-button is held for more than 5 seconds. This
Page 11 of 33
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)