KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 23 of 80
If any of the above phenomena is detected, stop the engine immediately and contact
the nearby dealer.
Methods of Starting the Agricultural Inter-cultivator
Starting by Hand:
1.
Open fuel switch.
2.
Put engine speed lever in the start position
3.
Lock Auto-cut off switch.
4.
Hold recoil starter handle.
5.
Pull the starting handle slowly until you feel the resistance, then release it slowly.
6.
Push the decompression lever down by hand to no compression position. It will
get back automatically by itself after the engine gets started.
7.
Starting: hold the starting handle with two hands, pull the rope lightly until you feel
the resistance, then pull the rope fast with strength.
8.
If it is not easy to start the engine when the weather gets cold.
You could take down the refuel screw on the cylinder cover and fill in 2ml oil before
starting.
Note
: Tighten the refuel screw on the cylinder cover except filling oil in order to avoid
rain and dust from getting in to the engine and wearing causing damage to the engine.
Operation
(Note: breaking-in must be performed before the using the Inter-cultivator)
1.
Using a slow shift:
•
The left hand should grasp the clutch handle tightly making the clutch
separated.
•
The right hand should pull the shift bar backwards, make sure the shift casing
is in the slow shift position, and observe whether it reaches the right position
or not. Then the right hand should grasp the right handle.
(Note: Do not grasp the reversing bar)
i.
Loosen the clutch handle gradually, the clutch will combine, and the
Inter-cultivator can run at a slow speed.
ii.
The right hand should increase the throttle properly so that the motor
can run at a speed of 5 km/h
2.
Using a fast shift:
•
The left hand should grasp the clutch handle tightly making the clutch
separated.
•
The right hand pushes the shift bar forwards, make sure the shift casing is
located in the fast shift position, and observe whether it reaches the right
position or not. Then the right hand should grasp the right handle.
(Note: Do not grasp the reversing bar)
•
Loosen the clutch handle gradually, the clutch will combine, and the Inter-
cultivator can run at a fast speed.
•
The right hand should increase the throttle properly so that the motor can run
at a speed of 10 km/h.
3.
Using a reversing shift:
•
The left hand should grasps the clutch handle tightly making the clutch
separated.
•
The right hand should pull or push the shift bar to the neutral shift and observe
whether it reaches the right position or not. The fore finger of right hand should
grasp the trigger of the reversing shift first, then the right hand should grasp
the reversing handle.