KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 14 of 80
Picture 5
Picture 6
1.4
Gear Choice
Gear box has 5 shifts, including neutral position. The gears are optional as given
below.
Gear box
Intercultural/Weeding Operations box(Using
with chain box together)
Transmission speed(km/h)
Blades rotary speed (rpm)
Forward
Stop
Back
Fast
Stop
Slow
Slow
Fast
Neutral
Slow
Fast
High
Low
Neutral
High
Low
2.55
4.83
1.82
3.45
553
299
311
168
Changing the gear
•
Counterclockwise turn the throttle switch to the right position (mini).
•
Clench clutch handlebar, and make clutch open.
•
Change shift lever to the gear you need.
•
Loosen clutch handlebar, make machine into the changed gear, then open the
throttle to increase the speed into the work.
•
If necessary, we may start engine to check if clutch is working.
2 Pay attention to the following while using Intercultivator
2.1
When using Intercultivator , you should pay attention to the working situation and
the sound, check the connection. If there is abnormal situation, you should stop the
Intercultivator and check.
2.2
Never carry out work in heavy load condition if Intercultivator has not been used for
some time, especially for the new ones or the repaired ones.
2.3
Pay attention to the oil level of diesel engine and gear box. Please refuel oil in
insufficient condition.
2.4
Never cool the diesel engine in the way of water-pouring.
2.5
Prevent Intercultivator from falling down when Intercultural/Weeding Operations.
2.6
Never install mini Intercultivator with rotary blades work on sand or stone to avoid
damaging blades.
2.7
After Intercultural/Weeding Operations, pay attention to clear away dirtiness in the
Intercultivator , such as mud, grass and oil stain.
2.8
Frequently wash the sponge in the air filter and change oil more often.
2.9
Ridging or weeding: Assemble ridging or weeding blades to the
Intercultural/Weeding Operations box, turn handlebar to the direct of engine. When
Intercultural/Weeding Operations, Intercultural/Weeding Operations box is front and
gear box is rear. According to the falling soil position, we adjust mud fender or side
mud fender.
3. Adjustment of belt tension