KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 12 of 80
Figure 2. Intercultural/Weeding
Operations device
Figure 3. Ditching device
Ditching & Ridging:
Knock down the adjustment screw before the ditcher is fixed. Subject
to the adjustment of the width and height for ditcher, the ditching can be conducted. (See
figure 3)
Short Distance Transport:
When fixing the forearm of the wagon box on the trailer and
wheels on the transmission shaft of the running part, the machine can be used for
transportation. The rated load is 250kg, under normal rotation speed of the diesel engine,
speed of the fast shift is about 10km/h and that of the slow shift is about 5 km/h.
Multi-Functional Working:
Dismount protection cover of the gear-box (No.2 in Figure 1),
unscrew the bolts away from the rear part of the main shaft, and take the cover for keys
out of the shaft, fasten the self-contained belt pulley or coupling onto the gear-
box’s main
shaft’s rear part with screws. Type A of common V belt is adopted for belt pulley’s cross
section. Rated rpm of the belt pulley is 3000 rpm. When the corresponding devices are
equipped, pumping water, spraying, threshing, reaping, generating electricity, etc. are
realized. (Above additional implements are in exploration process.
Assembly - KK-IC-350D//357D & KK-CRT-550D
Note
: Two gear boxes are provided. One for tyre rotation and another one for tines
rotation. Both the gear boxes have two speeds High and low. Air filter is provided with 2-
stage (primary and secondary) filtration.
Unpacking Assembly
1.
Take out Intercultivator and accessories.
2.
Fix the body of Intercultivator , install walking wheels, then use pin 8×40 and clip to fix
them. Install rear wheels
in the appropriate height
, then use lock bolt to fix it.
3.
Intercultural/Weeding
Operations/ditching
blades
installation:
install
Intercultural/Weeding Operations blades or ditching blades on both sides of output
shaft, edge towards forward, and then use pin
M8×40 and clip to fix it.
4.
Mud fender (or narrow mud fender) and side mud fender installation: Install left and
right mud fenders on the Intercultivator , fixing with bolt M6×12 (8 pcs) and locknut M6
(8 pcs), and screw up by spanner. The adjustable part of mud fender place is as the
picture. Then install side mud fender on both sides and screw up small handles.
5.
Handle bar installation: assemble handle bar components on Intercultivator . The
handle bar frame position is symmetrical accordingly for the Intercultivator , then use
the locked pin to fix the frame.