KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-300D / 307D / 350D / 357D
KK-CRT-550D
: +91.80. 6835 7800
Page 22 of 80
•
If your engine is not breaking in yet, improper usage will shorten the life of engine.
The initial 20 hrs is the break-in-period. The operator must obey the following
rules:
Running in for 5 minutes after first start:
Running with low speed and low load before
the engine gets hot. Avoid running with high speed and full load, or low speed and no load.
Avoid running with overload:
During break-in period, the engine can't run with full load,
but can run with 3000rpm and 50% load.
Change engine oil regularly:
After working for 20hrs, change the oil when engine is still
warm, otherwise it will be difficult to drain the residual oil in the engine.
Oil Bath Type Air Filter
:
•
Check the oil level before operating.
•
Fill oil up to upper limit. If oil is dirty, change it. Please use diesel to clean oil
bath element frequently, then dip the element in the oil and squeeze out
extra.
Starting the Engine
Note
: The shift bar must be in the neutral position
1.
Start the diesel engine according to the procedures stipulated in the instruction
manual for the diesel engine.
2.
The diesel engine should run at a low speed (1500-2000 rpm) under no load for
2-3 minutes.
3.
Check whether the diesel engine runs normally or not. If it is abnormal, stop the
engine and have a check.
Warning:
•
Be sure to operate the engine in a good ventilated place in order to avoid exhaust
poisoning.
•
Avoid letting hands, body & clothes entangle in output shaft, belt pulley, V-type
belt pulley and other moving parts, so as to prevent from getting injury.
•
Stop the engine first and then maintain the movable parts and other parts around
it. Make sure there are no tools and sundries in the body of the engine before
operating.
Run engine for 5mins to warm up
Note:
•
The muffler becomes very hot during and
immediately after operation. Don’t touch
it.
•
The air filter will inhale the air around itself when the engine works.
•
Don't let the hands, body and clothes approach the air filter to avoid injury.
After the engine becomes warm, put the speed lever on necessary position to run the
engine.
Note:
•
Be sure to use the speed lever to adjust the speed of engine.
•
Do not loosen the speed limit screw and fuel control screw; otherwise the speed
and output of engine will be abnormal.
While the engine is running
•
If the engine gives out black smoke continuously, it is because the engine is
overloaded. The belt pulley of the engine or that of the powered equipment
must be adjusted.
•
Pay attention to the following points when the engine is running:
i.
Whether there is abnormal sound and vibration?
ii.
Whether the exhaust is normal?
iii.
Whether the engine gives out white or black smoke continuously?