17
INSTALLATION
INSTALLATION
■
■
Position the cords.
■
➤
Place the washer on the end of one cord into the first slot from the rear on the inside of the end plate, as shown. Loop the
cord behind the end plate back through the second slot from the front and pull it taut to seat the washer
■
➤
Cut the washer from the end of the other cord and tie the cord to the cord tensioner using a square knot. (There are two
cord tensioners in the headrail; one is a spare.) Trim the end of the cord to about
1
⁄
2
".
■
➤
Loop the cord from the tensioner around the second slot from the rear. The top of the loop must be the cord from the cord
tensioner. Be sure the cord is not twisted.
■
■
Remove slack from the cord by moving the cord tensioner away from the end plate it is looped around.
■
➤
If the tensioner must be moved more than one-third of the headrail width away from its end plate to remove slack, re-tie the
knot and trim the excess cord.
■
➤
Do not put tension on the cord at this time. Just remove the slack.
Washer on Inside,
First Slot from Rear
Trim
Top from
Tensioner
Bottom from
Moving Rail
Loop Around
Second Slot
from Rear
