12
INSTALLATION
INSTALLATION
Inside/Ceiling Mount
Mount the Installation Brackets
■
■
Mark 8" in from each jamb. This marks the
center points of the two end brackets.
■
➤
Mark the locations of any additional
brackets, spaced evenly between the two
end brackets.
■
■
Center the brackets on your marks and mark the screw holes.
■
➤
The minimum casement depth for mounting the installation brackets is
1
⁄
2
".
Mark both of the winged screw holes with shallow mounting depths.
■
➤
The minimum casement depth for a fully recessed mount varies with valance
type and fabric cell size, as shown in the table. Mark the center screw hole
when depth permits.
■
■
Drill the screw holes using a
3
⁄
32
" drill bit.
CAUTION:
Use drywall anchors when mounting into drywall. Use
the drill bit size recommended by the manufacturer.
■
■
Attach the installation brackets using the screws provided.
IMPORTANT:
Be sure the front edges of the installation brackets
are level and aligned to each other. Use shims if necessary to level
the brackets.
Mount the Headrail
■
■
Mount the headrail into the installation brackets.
Do not remove any components from the headrail.
Both end plates should remain attached to the
ends of the headrail.
■
➤
Place the front groove on the headrail onto the
front lip of the installation bracket.
■
➤
Position the end of the headrail opposite the
fabric stack flush against the jamb. This leaves
a gap on the stationary rail side. The stationary
rail fills this gap when anchored.
■
➤
Rotate the rear of the headrail up and push back until the headrail snaps in place.
Window/Door Opening
8"
Space Evenly
Jamb
Jamb
Space Evenly
8"
Place Groove onto
Front of Bracket
Snap in Place
Gap
Left Stack Shown
Flush
Minimum
1
∕
2
"
Use Center Hole
When Depth Permits
Valance
Type
Fully Recessed Depth
3
⁄
4
" Cell
1
1
⁄
4
" Cell
Aluminum
3
7
⁄
8
"
4
5
⁄
8
"
Traditional
4
1
⁄
4
"
5"
